News

Photographing a Fault So It Can Be Assessed
2026-11-06
How to photograph a weld or fitment fault so it can be assessed remotely: wide and close frames, raking light, scale, a plain background and unedited files with the order reference.
What a Warranty Claim Actually Covers
2026-11-06
A claim concerns the part, not the project: workmanship and material are covered, wear items and consequential costs are not, and the original order record defines what was agreed.
Routing a Pipe Around an Obstacle, or Moving the Obstacle
2026-11-03
Every bend costs pressure, and every obstacle moved costs something else. Which parts can be moved, where a tight bend is tolerable, and how to support a new route.
Heat Sources Near a Hose in a Tight Bay
2026-11-03
In a tight bay a hose has no air gap to lose heat into. Radiant versus conducted heat, why failures start at the clamp, and when to shield rather than reroute.
What a Body Kit or Wider Arch Changes Underneath
2026-11-03
A wider arch adds room outside the wheel well, not inside it. Liner contact, tip position, cut lines, loaded tyre clearance and fixings into thin panels.
Working Near a High-Voltage System Under the Bonnet
2026-11-03
Hybrids and electric cars put high-voltage parts under the bonnet. How to identify the system, why isolation is not switching off, and when metalwork should stop.
Airflow Through a Grille When the Core Sits Behind Something
2026-11-03
A core only cools with the air that reaches it. What blocks flow without touching, why duct sealing beats a bigger core, and how the exit path decides the result.
When the Engine Bay Is Simply Too Tight for the Part
2026-11-03
Tight means no access, not no space. How to tell a tight fit from a touching one, what a drawing must show, and the three-question rule before ordering a part.
Page 7 of 36
Total 36 Pages
Go To