Nov.2026 06

What a Warranty Claim Actually Covers

Introduction
A claim concerns the part, not the project: workmanship and material are covered, wear items and consequential costs are not, and the original order record defines what was agreed.
Details

The part, not the project

A claim is about the part that left the workshop, not the project it went into. The question is narrow: was that component made and supplied as agreed? Labour, dyno time and a missed weekend sit outside it. Keeping the argument on the metal is what lets a claim settle at all.

That matters because most disputes start somewhere else. An owner is angry about a rattle, a deadline, a bill from a second workshop. The claim itself is smaller than the story around it, and whoever reads it will reduce it back to the component. Do that reduction early and the rest follows.

The workmanship side

Workmanship covers what a fabricator controls: a weld that was not fused through, a flange that went out of flat, a hanger fixed in the wrong place, a bend that collapsed in the die. These show on a bench and they are the strongest ground for a claim, because they do not depend on how the car was driven.

Look at the joint rather than the surface. A dressing mark in a brushed finish is cosmetic; a crater at the end of a weld, a gap bridged with filler, or porosity that opens under load is not. Photograph the joint close, in focus, with enough surrounding pipe to show where it sits.

What is not covered

Wear items go first: gaskets, clamps, bolts, springs, isolators and anything consumable supplied with the kit. They are expected to be replaced at service. So is anything that failed because it was asked to do a job it was not built for, such as a system run with a much hotter tune and no heat management.

Damage in transit belongs to a different process and should be raised as transit damage rather than as a fault. Fitting damage belongs to fitting. Once a part has been cut, drilled, bent or heated after delivery, the claim narrows to whatever can still be shown to have been wrong at dispatch.

Consequential loss

A manufacturer answers for the part. It does not answer for the cost of the surrounding failure: a hire car, a lost entry fee, a second workshop's invoice, an engine damaged downstream. Those are real costs and they hurt, but they belong to the owner's insurance or to whoever caused them.

Say this at the start of a claim rather than at the end. An owner who expects the whole bill to be met will read every later message as a refusal, and the negotiation over the part itself gets buried. Most claims that turn hostile were not hostile at the beginning; they were misread.

Why the original order matters

The order is the specification. Grade, finish, diameter, wall, flange pattern, hanger positions and any agreed test all sit in that record, and a claim is checked against it. An owner who supplied a drawing is held to the drawing, not to a later idea of how it should have looked.

This is why the order record is worth keeping: the sample, the drawing and the confirmation all describe the same part. When those agree, a claim is a short conversation about a joint. When they do not, it turns into an argument about what was ordered rather than about what was made.

How the claim is read

Someone who has welded the same joint many times reads a claim in a fixed order: what failed, where, under what conditions, and what the part was asked to do. Photographs first, then the order record, then the story. A claim that leads with the story is read more slowly and settled less generously.

The people who make this work have been at it since 2009, and the workshop behind the parts still reads a claim the way a small shop does: on the bench, with the part in hand. That is not a legal position but a practical one, and it is why the custom work route records every stage from drawing to confirmation.