News

Dimensional Inspection After Welding
2026-10-29
After welding, every dimension has moved a little. Reading a part against the right datum, in free state, is what separates a real non-conformance from the movement the welder predicted.
Hydrostatic Versus Pneumatic Testing: The Safety Difference
2026-10-29
Water and air store very different amounts of energy, and that single fact decides which test belongs on a fabricated tank. A practical look at what each method proves, how to prepare for it and what to record.
Bend Test and Nick Break: What a Destroyed Weld Proves
2026-10-29
A joint can look correct and still be attached only at its edges. Bending and breaking a coupon reads the inside of the weld, which is the only place that failure shows.
Visual Inspection: What a Trained Eye Catches First
2026-10-29
Visual inspection is the cheapest check in a fabrication shop, but only when the light, the angle and the reference sample are fixed. This article sets out what a trained eye actually looks for on welded exhaust and tank work.
Assembly Order: What Has to Be Welded Last
2026-10-29
Some joint always has to be welded last, and finding it decides the whole order. This covers access, shrinkage, sub-assemblies, machining after welding, inspection points that disappear, and how to write a sequence that survives a shift change.
Slip, Interference and Weld Gap: Reading a Fit
2026-10-29
Slip, interference and weld gap are three intentions, not three grades of tightness. This article explains where each belongs, how heat closes or opens a gap along a joint, how to measure a fit, and what a consistently bad fit says about the drawing.
Cutting a Compound Angle by Hand
2026-10-29
A compound angle is two planes at once, and no square will lay it out. Here is the wrap-around method for developing a tube surface, why two single cuts often beat one compound cut, and how to read the gap before the torch is lit.
Bending Sequence in a Multi-Bend Tube
2026-10-29
A multi-bend tube can be made in more than one order and the orders do not give the same part. This covers middle-out and end-first sequences, straight length between bends, rotation control, springback and when a bend becomes a welded joint.
Page 8 of 33
Total 33 Pages
Go To