News

Where Fabrication Time Actually Goes on a Custom Part
2026-10-13
On a custom part the metal work is usually the shortest stage. Requirement, drawing or sample data, mould making and testing, samples and customer confirmation are where the time sits.
3D Scanning a Factory Part Before Making a Replacement
2026-10-13
Scanning a factory part captures surface geometry faster than hand measurement, but the point cloud still needs an engineer. What a scan cannot show, and why a sample still proves the fit.
Jigs and Fixtures: Why Repeatability Depends on Them
2026-10-13
Jigs and fixtures hold a part in a known position so the tenth part matches the first. What they control, how they resist weld shrinkage, and where hand judgement still matters.
Hydroforming and Its Place in Intake and Exhaust Work
2026-10-13
Hydroforming uses internal fluid pressure to form continuous transitions without welds. Where it suits intake and exhaust work, what it cannot form, and when fabrication still wins.
Cutting Tube for Fabrication: What the Cut Does to the Joint
2026-10-13
The cut sets the ceiling on joint quality. Square faces, burr control, clamping damage and the differences between saw, bandsaw and rotary cuts all decide how a weld closes.
Why Exhaust Flanges Distort and How Fabricators Prevent It
2026-10-13
Welding heat bows a flange and the joint leaks. How distortion forms, how welding sequence, clamping, backing and flange design reduce it, and how to check a face before bolting up.
V-Band Versus Slip Joints: Sealing and Service Trade-offs
2026-10-13
Slip joints and V-band joints both seal an exhaust, but they fail differently and come apart differently. A look at sealing, reuse, alignment and where each joint belongs.
Choosing Bend Radius for an Exhaust Run
2026-10-13
Bend radius decides how much a tube wall deforms and how smoothly gas turns. How radius, wall thickness, work hardening and packaging constraints trade off in an exhaust run.
Page 29 of 36
Total 36 Pages
Go To