News

A System That Touches the Body Only When Hot
2026-10-26
An exhaust that knocks only after it is hot has closed a clearance through thermal growth, not come loose. How to separate expansion from a bad hanger, a buzzing heat shield or a mis-set run, and how witness marks locate the contact point.
A Sensor Code That Appeared After a Downpipe Was Fitted
2026-10-26
A sensor code on the first drive after a downpipe is usually the pipe, not the sensor. How boss position, upstream leaks and wall material change the reading, and which checks separate a heater code from a mixture code.
Hangers That Broke at the Weld
2026-10-26
Hangers that snap beside the weld are cracked by fatigue, not torn by load. Why the weld toe concentrates stress, how restrained expansion finds the weakest joint, and how to read the fracture face before rebuilding.
A Flange That Will Not Seal Without Excessive Torque
2026-10-26
A joint that only seals when the fasteners are far too tight is being closed by bending metal, not by load on the gasket. How flanges go conical, how to tell it from a collapsed gasket, and the checks that prove it.
A Gasket That Blew Out Twice in the Same Place
2026-10-26
A gasket that fails at the same joint twice is not a gasket problem. How uneven flange faces, bore steps and unsupported joints extrude a gasket, and the checks that find the gap before you fit another one.
A Part That Fit on the Bench but Not on the Car
2026-10-26
A part that closed perfectly on a jig can still refuse the car. Why the vehicle is not the fixture, how two datums set independently hold a joint open, and the checks that separate a wrong part from a wrong position.
Bolt Heads That Rusted Before the Pipe Did
2026-10-26
Hardware is a small anode clamped to a large cathode, and a bolt is a stack of crevices. How to tell galvanic and crevice attack from rust running down from above, using a magnet and a cloth.
A Polished Finish That Went Dull in Storage
2026-10-26
Polish does not fade on its own. Wrapped damp, acidic paper, cured film adhesive and fingerprints each dull a surface differently. The solvent test that tells a deposit from an etch before you polish.
Page 14 of 36
Total 36 Pages
Go To